Axxes Viaxxes Sat Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Axxes Viaxxes Sat. Axxes Viaxxes Sat 20 pagina's.

CHAPTER 1

INSTALLING THE BADGE

CONNECTION TO THE VEHICLE'S POWER SUPPLY

Note: This installation should be carried out by a qualiﬁed vehicle

electrician.

1. Use the cigarette lighter cable supplied. Make sure the cable is long enough,

then remove the lighter plug and any excess cable.

2. Locate the connection points in the vehicle using the diagram below.

The ignition signal wire should be connected to the vehicle ignition.

3. Before connecting the cables to the vehicle, install a 5 amp time-delay fuse in

series with the power wires (red and black wires). If the vehicle's power supply

is already protected, this step is not necessary.

4. Finally, connect each wire to the connection points you have identiﬁed

(permanent battery supply, ignition and vehicle ground).

RED

+12V / +24V Vehicle battery supply

BLACK

+12V / +24V Ignition signal

Vehicle ground

WHITE

CHAPTER 2

ACTIVATING THE BADGE

To activate your Viaxxès SAT, you will ﬁrst need to conﬁgure it.

Use the arrow buttons

to navigate the menu

If you make a mistake, disconnect and then reconnect the badge

to restart the conﬁguration.

Press

twice

to enter a menu

Press

to leave a menu