Epson 220 Handmatig - Pagina 23

Blader online of download pdf Handmatig voor {categorie_naam} Epson 220. Epson 220 29 pagina's. Epson printer parts manual

Pagina afdrukken

Using the Tear Off/Bin button

After the printer finishes printing your document, check that

the Tear Off/Bin lights are not flashing. Then press the Tear

Off/Bin button. The Tear Off/Bin lights start flashing and the

printer advances the paper to the tear-off edge.

Note:

If the Tear Off/Bin lights are flashing, the paper is in the tear-off

position. If you press the Tear Off/Bin button, the printer feeds your

paper to the next top-of-form position.

Advancing paper to the tear-off position

automatically

To automatically advance your printed documents to the tear-

off position, you need to turn on the auto tear-off mode and

select the appropriate page length for continuous paper in the

default-setting mode. For instructions, see "About Your

Printer's Default Settings" on page 25.

When auto tear-off is on, the printer automatically advances

the paper to the tear-off position whenever it receives a

full page of data or a form feed command followed by no

more data.

Adjusting the tear-off position

If your paper's perforation is not aligned with the tear-off

edge, you can use the micro adjust feature to move the

perforation to the tear-off position. Follow the steps below.

Caution:

Never use the knob to adjust the tear-off position while

the printer is turned on; this may damage the printer or

cause it to lose the tear-off position. The knob can be

used when the printer is turned off only.

Note: Your tear-off position setting remains in effect

until you change it, even if you turn off the printer.

1. Make sure the Tear Off/Bin lights are flashing (the paper

is at the current tear-off position). If necessary, press the

button to advance the paper to the tear-

Tear Off/Bin

off position.

2. Open the paper guide cover.

3. Hold down the

Pause

Pause light begins flashing and the printer enters the micro

adjust mode.

button for about three seconds. The

4. Press the

D button to feed the paper backward, or

LF/FF

press the

Load/Eject

until the paper perforation is aligned with the tear-off edge.

Note:

The printer has a minimum and a maximum tear-off position. If

you try to adjust the tear-off position beyond these limits, the

printer beeps and stops moving the paper.

5. After you set the tear-off position, press the

to turn off the micro adjust mode.

6. Tear off the printed pages.

When you resume printing, the printer automatically feeds the

paper back to the top-of-form position and begins printing.

2/99

EPSON LQ-2080

U button to feed the paper forward

tear-off-edge

Pause

EPSON LQ-2080

button

- 23