ayas OBRA-260-2K-M Gebruiksaanwijzing - Pagina 15
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} ayas OBRA-260-2K-M. ayas OBRA-260-2K-M 20 pagina's. Single inlet centrifugal fan
Pagina afdrukken
Electrical Wiring Diagram
THINGS TO BE CONSIDERED WHEN MAKING THE ELECTRICAL CONNECTION
1. The electrical connection of the product should only be made by authorized persons.
2. Make sure that the product is connected to the installation in accordance with the electrical
values written on the label.
3. Before connecting the electrical cables, definitely cut off the electricity from the source.
4. Make sure that the main power supply is turned off when connecting the power cables, even
if the product is turned off.
5. After checking whether the electrical connection information (voltage, power, frequency,
etc.) specified on the product match with the place where the installation will be made, the
product should be assembled.
6. For safety reasons, the grounding terminal on the terminal must be connected to the
building ground line.
7. The product wiring must be as in the electrical wiring diagram.
8. It must be connected to the fixed installation in accordance with the installation rules,
together with a switch with contact separation in all poles.
When you run your product for the first time;
•
Before connecting the electrical cables, always cut off the electricity from the source. Do not
operate the product without making sure that the electrical connections of the product are
safe and as shown in the electrical wiring diagram.
•
Make sure all equipment is properly connected.
•
Make sure that the grounding connections are as shown in the electrical connection
diagram.
•
Make sure that the cable and electrical connection box are closed correctly and watertight.
•
Make sure that the air outlet direction is the same as the direction shown on the labels on
the product. The blades should rotate in the correct direction.
•
Make sure that there are no objects obstructing the air flow, otherwise these objects will be
thrown out by the fan.
•
There should be no vibration during the operation of the product, and no internal rubbing or
knocking sounds caused by the rotation of the fan.
•
In case the product comes into contact with water or any electrical safety device is burned,
the electrical connection must be immediately disconnected from the mains. When the
product is to be operated again, the entire installation should be checked again.
•
If you encounter any problems, inform the authorized persons.
When you start to use the product continuously, in case of any malfunction, the technical
service must be contacted in order to determine the type of malfunction and rectify the
malfunction.
Never try to intervene yourself.
15