Accuris W3200-500-E Bedieningshandleiding - Pagina 8
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Accuris W3200-500-E. Accuris W3200-500-E 16 pagina's. Precision balance
3-3 Count weighing
This function is used to determine a total number of pieces of similar weights. A known
number of pieces is weighed as a reference, and the average weight of each piece is automatically
calculated. An unknown quantity of pieces can then be calculated.
1. Place an empty container on the weighing pan.
2. Press the TARE key, the balance will display 0.0000g.
3. Press "Count/Enter" key, repeat to choose the known reference # of pieces (example 10
pieces)
4. Place the known # of pieces onto the weigh pan.
5. Press "METRIC" key, and the reference number will be displayed along with "PCS"
6. Remove the reference quantity and the display will show 0 PCS.
7. Now you can add to the pan an unknown quantity and the quantity will be calculated.
Press the METRIC key to change out of the counting mode.
3-4 Percent Deviation
This mode is used to calculate the percentage of weight a sample varies from a reference weight.
1. Empty the weigh pan;
2. Press the TARE key to zero the display; "0.00 g" will be displayed
3. Place the reference weight onto the weigh pan, and close the doors;
4. Press the PERCENT key. 100% will be displayed;
5. Remove the reference weight from the weigh pan;
6. Place an object to be compared to the reference weight onto the weigh pan and close the
draft shield doors.
7. A percentage value of the deviation between reference and the sample will be displayed.
3-5 Inspect Mode
The Inspect mode is available to determine if a weighed object is within a pre-set range.
Display will signal: LOW or HIGH (with warning sound of buzzer) or OK to indicate the results.
1) Press the MENU key, and then use the TARE key to scroll through options until
"InSPCT" is displayed.
2) Press "COUNT/ENTER" to choose Inspect mode.
3) "SET HI" is displayed, press COUNT/ENTER key.
4) Press COUNT/ENTER to set position of the decimal point. Press TARE key to move the
decimal point, press COUNT/ENTER to confirm choice.
5) Set the value of the High limit: press COUNT/ENTER to increase the value, press TARE
to decrease the value.
6) Press MENU and then COUNT/ENTER to confirm the High limit set point.
7) Press TARE to switch to SET LO, then press the COUNT/ENTER key.
8) Press TARE to move the decimal point, press COUNT/ENTER to confirm choice.
8