Cisco 2970 - Catalyst Switch Handmatig - Pagina 3
Blader online of download pdf Handmatig voor {categorie_naam} Cisco 2970 - Catalyst Switch. Cisco 2970 - Catalyst Switch 19 pagina's. Ios software release 12.1(14)ea1
Ook voor Cisco 2970 - Catalyst Switch: Product Bulletin (5 pagina's), Product ondersteunings bulletin (6 pagina's), Product ondersteunings bulletin (6 pagina's)
Pagina afdrukken
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches
need to provide an RJ-45-to-DB-25 female data terminal equipment (DTE) adapter if you want to
connect the switch console port to a terminal. You may order a kit (part number ACS-DSBUASYN=)
containing the adapter from Cisco. The PC or terminal must support VT100 terminal emulation. The
terminal emulation softwarefrequently a PC application such as Hyperterminal or Procomm Plusmakes
communication between the switch and your PC or terminal possible during the setup program.
Follow these steps to connect the PC or terminal to the switch:
1.
Be sure that your PC or terminal emulation software is configured to communicate with the switch
via hardware flow control.
2.
Configure the baud rate and character format of the PC or terminal to match these console port
default characteristics:
9600 baud
8 data bits
1 stop bit
No parity
3.
Using the supplied rollover cable, insert the RJ-45 connector into the console port.
4.
Attach the supplied RJ-45-to-DB-9 female DTE adapter to a PC, or attach an appropriate adapter
to the terminal.
5.
Insert the other end of the supplied rollover cable in the attached adapter.
6.
Run the terminal emulation program if you are using a PC or a terminal.
Table A-1: Console Port Signaling and Cabling Using a DB-9 Adapter
Console
RJ-45-to-RJ-45
Port
Rollover Cable
(DTE)
RJ-45
Signal
Pin
RTS
1
http://www.cisco.com/warp/public/473/9.html (3 of 19) [9/4/2003 12:36:02 PM]
RJ-45-to-DB-9
Terminal
Adapter
RJ-45
DB-9 Pin
Pin
8
8
Console
Device
Signal
CTS