Sharp XM-1446S Bedieningshandleiding - Pagina 12

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Sharp XM-1446S. Sharp XM-1446S 33 pagina's. Monitor television

Pagina afdrukken

How to Operate the Remote Control Transmitter

TELEVISION Mode

Channel Selector

Channel to be selected

| Channel selector buttons to be pressed.

Channel 1 ~

Press the Cy ~ cy buttons.

Channel 10 ~ 19

Press the ¢y button (''1-" displayed for about 6 seconds), and then the

cy ~ © button.

Note:

Be sure to press the buttons within 5 seconds after the ¢y button

is pressed, because the ¢4y button is cancelled in about 6 seconds.

Channel 20 ~ 29

Press the & button (''2-" displayed for about 6 seconds), and then the

cy ~ Cc button.

Note:

Refer to the note for Channel 10 ~ 19.

Press the €4 button (''3-" displayed for about 6 seconds on the screen),

and then the & ~ (4 button.

Note:

Refer to the note for Channel

10 ~ 19.

Channel 30 ~ 39

AUX

(TV)

Button

(RM-AV2S

and

RM-AV3S only)

Use this button to select the TV sound

source.

The button

is inoperative in the

standby mode.

Procedure:

Press the power ON/OFF button to switch

the TV set to the picture mode.

Press the AUX (TV) button to select the

TV sound source.

TV/Audio

Selector

(RM-AV2S

and

RM-AV3S only)

When this selector is set to the TV position,

the digit keys within the [__] can be used to

select TV channels.

Therefore, make sure the selector is set.to

the TV position when selecting TV channels.

- Sound Mode Selector ( VO,

The sound mode selector is used to select

the main, sub or main + sub audio modes

of bilingual broadcasting, and to select the

stereo

or mono

mode

while

receiving

stereo signals.

If this button is pressed during the main

audio mode, reception switches over to

the sub audio mode. If it is pressed again,

reception switches over to the main + sub

audio mode. If it is pressed a third time

reception returns to the main audio mode.

When this button is pressed while receiv-

ing stereo signals, the mono mode will be

selected. When this button is pressed a

second

time, the stereo

mode

will be

selected.

Each sound mode indicator will be displayed

on the screen as shown below.

[ Sound Mode

Main audio

Sub audio

Main + sub audio

On Screen Display

MAIN

SUB

MAIN + SUB

STEREO

TV/Video Selector (TV/VIDEO)

In case the playback picture does not appear

in the connection shown on page 15. Press

the TV/Video selector to make the picture ap-

pear. The "AV" (Audio/Video indicator) will

be displayed for about 3 seconds in the up-

per corner of the screen.

When

the TV/Video

selector

is pressed

again, the set is switched to receive on-air TV

broadcasts,

and the channel

programme

number will be displayed for about 3 se-

conds in the upper right corner of the screen.

Channel Call Button

¢ When the Channel call button is pressed,

the channel programme

number will be

displayed in the upper right corner of the

screen.

¢ The channel programme number display

can also be erased by pressing this button

once again.