Sharp Notevision PG-D40W3D Installatiehandleiding - Pagina 16

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Sharp Notevision PG-D40W3D. Sharp Notevision PG-D40W3D 35 pagina's. True xga/wxga data projectors
Ook voor Sharp Notevision PG-D40W3D: Gebruikershandleiding (2 pagina's), Specificatieblad (2 pagina's), Specificaties (2 pagina's), Brochure & specificaties (2 pagina's)

Sharp Notevision PG-D40W3D Installatiehandleiding

Controlling the Projector via LAN

After connecting the projector to your network, enter the projector IP address in
"Address" on Internet Explorer (version 5.0 or later) using a computer on the network to
start a setup screen that will enable control of the projector via the network.
Controlling the Projector
Using Internet Explorer

(Version 5.0 or later)

Complete connections to external
equipment before starting the operation.
(See pages 21-25 of the projector's
operation manual.)
Complete the AC cord connection. (See
page 25 of the projector's operation
manual.)
Note
When connecting the projector to the LAN, use
a commercially available LAN cable (UTP cable,
Category 5, cross-over type). When
connecting the projector to a hub, use a
straight-through cable.
1
1
Start Internet Explorer (version 5.0
or later) on the computer.
2
2
Enter "http://" followed by the
projector IP address set by the
procedure on page
"/" in "Address", and then press
the "Enter" key.
When "DHCP Client" is set to "OFF" on the
projector, IP address is 192.168.150.2. If you
did not change the IP address in "3. Setting
up a Network Connection for the
Projector" (pages 14-15), enter
"http://192.168.150.2/".
3
3
A screen for controlling the
projector appears, ready for
performing various status
conditions, control, and settings.
-16
15
followed by