ActronAir easyconnect LRE-100AS Installatie- en installatiehandleiding - Pagina 9

Blader online of download pdf Installatie- en installatiehandleiding voor {categorie_naam} ActronAir easyconnect LRE-100AS. ActronAir easyconnect LRE-100AS 20 pagina's. Ultraslim ducted, bulkhead ducted and cassette systems

Pagina afdrukken
Installation Guide
4. INSTALLATION METHOD
smart port
Fig 4-4
b. Conection to indoor unit with no wired connection.
If you want to use both wire controller and WIFI control at the
Run the 6m Extension Cable (Supplied) from the Smart Port Receiver CN2
same time , you can use the CN3 port on the smart port
4. INSTALLATION METHOD
connector to the indoor pcb terminal CN40. See Figure 4-10.This is the
terminal to connect the wire controller ( shown as Fig 4-4).
required method of installation if using exclusively with Wi-Fi or if using
with a remote controller.
3.Wiring gure
smart port
Please con rm the connective wires group-1 (shown in
Fig 4-3) , one side is connected to the port CN40 on indoor
main PCB board , another side is plugged into CN40 on the
WIFI smart port terminal . On some case , when you need
a extension cord , please contact your distributor .
If want to extent the wire ,please use extension cord
(purchased separately) . (See Fig.4-3)
6
4-core shielding wire
4-core shielding wire
Installation Guide - Easyconnect App
Document: 9590-4009 Ver. 2 201126
Easyconnect App
Extension cord
Figure 4-9
The connective wires group-2
Extension cord
(purchased separately)
Extension cord
Figure 4-10
wire controller
Mainboard
CN40
The connective wires group-1
Fig 4-3
7
9