Siemens EH8 HVB Series Informatie voor gebruik - Pagina 18
Blader online of download pdf Informatie voor gebruik voor {categorie_naam} Siemens EH8 HVB Series. Siemens EH8 HVB Series 24 pagina's.
Pagina afdrukken
en Troubleshooting
¡ If the fault code is not listed in the table, disconnect
the hob from the power supply and wait 30 seconds
before reconnecting it. If this display appears again,
contact customer service and specify the exact fault
code.
22.2 Information on the display panel
Fault
No displays light up.
The displays flash.
, , ,
,
+ power level and
audible signal
and signal tone
/
/
/
Home Connect is not
working properly.
The hood control is
not working properly.
Animations on the
displays
18
Cause and troubleshooting
The power supply has been disconnected.
Use other electrical appliances to check whether there has been a power failure.
▶
The appliance has not been connected as shown in the circuit diagram.
Connect the appliance in accordance with the circuit diagram.
▶
Electronics fault
If you are unable to rectify the fault, inform the technical after-sales service.
▶
The control panel is wet or an object is covering it.
Dry the control panel or remove the object.
▶
The electronics have overheated and one or all of the cooking zones have been switched
off.
Wait until the electronics have cooled down sufficiently. Then touch any button on the
▶
control panel.
There is hot cookware in the vicinity of the control panel. This may cause the electronics to
overheat.
Remove the cookware. The fault display goes out shortly afterwards. You can continue to
▶
cook.
There is hot cookware in the vicinity of the control panel. The cooking zone has been
switched off to protect the electronics.
Remove the cookware. Wait a few seconds. Touch any button. When the fault display
▶
goes out, you can continue cooking.
The cooking zone has overheated and has been switched off to protect the work surface.
Wait until the electronics have cooled down sufficiently before switching the cooking
▶
zone back on.
The cooking zone has been operating continuously for an extended period.
Individual safety switch-off is switched on. Touch any button to switch off the display so
▶
that you can set the cooking zone.
The operating voltage is incorrect and outside of the normal operating range.
Contact your energy supplier.
▶
The hob is not connected correctly.
Disconnect the hob from the mains. Connect the hob in accordance with the circuit dia-
▶
gram.
Demo mode is activated.
Switch off demo mode in the basic settings.
▶
Different causes are possible.
Go to www.home-connect.com.
▶
The hood control functions do not switch on.
Resetting and re-pairing the settings of the Wi-Fi home network
▶
In certain circumstances, the hob can perform self-maintenance tasks, e.g. a firmware up-
date, optimisation or troubleshooting.
Wait until the process is complete and only then switch the hob on.
▶
¡ If an error occurs, the appliance does not switch to
standby mode.
¡ In order to protect the appliance's electronic parts
from overheating or surge currents, the hob may
temporarily reduce the power level.