Ricoh Pro L5160 Handmatig - Pagina 10

Blader online of download pdf Handmatig voor {categorie_naam} Ricoh Pro L5160. Ricoh Pro L5160 12 pagina's. Additional function 2
Ook voor Ricoh Pro L5160: Handleiding Rip-instellingen (44 pagina's), Handleiding veiligheidsinformatie (32 pagina's), Snel aan de slag (32 pagina's)

Added New Drying Operation

[Overview]

Added the new drying operation to reduce media consumption between jobs.

This function described in this chapter is available from the following firmware versions.

System : 2.03 or later

Engine : 2.03:01 or later

[How to operate]

⚫

Prevent Drying After Printing

When "Prevent Drying After Printing" is set to "On" by following the steps below, the

machine does not dry the printed image after printing. So, it can reduce the amount of

media used, because the margins that are required for drying are reduced.

The undried part at the end of the printed image dries when you print the next job.

Press [Standard Procedure] key.

Press [Dry After Printing].

Press [Prevent Drying After Printing]

[ON]:

Do not dry the printed image after printing

[OFF]:

Dry the printed image after printing (Default)

Note:

If you use this feature and print the next image with a different print mode, drying

may not be enough. Therefore, it is recommended to print the next jobs in the same

print mode or in a print mode with a large number of passes. If you print with a

different print mode, print quality cannot be guaranteed.

The printed image is left on the post-heater, which may cause waving of the media

or melting the release paper (for adhesive media).

This function will not operate if you have specified the settings for "Auto Cutting

Media after Printing"

(*1): Also called "Roll to Cut", it can be work by changing the RIP settings. For

details, please refer to the separate "Solutions manual".

(*2): It can be work by [Standard Procedure] key -> [Media Settings] -> [Auto

Rewinding after Drying]. For details, please refer to the separate "Solutions

manual".

(*1)

or if "Auto Rewind after Drying"

(*2)

is set to "On".