Cisco 1941 Installeren en upgraden - Pagina 20

Blader online of download pdf Installeren en upgraden voor {categorie_naam} Cisco 1941. Cisco 1941 24 pagina's. 1900 series

Modules Internal to the Cisco 1941 Router
Figure 18
Note
Replace the cover. See
Step 12
Note
Installing a Blower
To replace a blower, perform the following procedure. To complete this procedure, you need a number 2
Phillips screwdriver or flat-blade screwdriver.
Remove the cover. See
Step 1
Locate the blower in the chassis. See the
Step 2
blower.
Remove the three screws from the blower as shown in
Step 3
Lift the blower from the chassis and disconnect the power cable.
Step 4
Insert the replacement blower.
Step 5
Installing and Upgrading Internal Modules and FRUs in Cisco 1900 Series ISRs
20
Installing the AC Cable
The AC cable should thread through the sheet metal channel on top of the PoE cable as shown
in
Figure
18.
"Opening and Closing the Chassis" section on page
If your Cisco 1941 ISR is wireless, reattach the wireless antennas.
"Opening and Closing the Chassis" section on page
Installing and Upgrading Internal Modules and FRUs in Cisco 1900 Series ISRs
"Locating Modules" section on page 7
Figure
12.
5.
5.
for the location of the