Cisco 3745 Snelstarthandleiding - Pagina 22

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cisco 3745. Cisco 3745 33 pagina's. Non-proprietary security policy
Ook voor Cisco 3745: Oplossingsoverzicht (16 pagina's), Upgrade-instructies (30 pagina's), Gebruikershandleiding (48 pagina's), Installatiehandleiding (12 pagina's)

Pagina afdrukken

1. Initial Configuration Using the Cli (Manual Configuration)

To proceed with manual configuration using the CLI, enter no.

Step 1

Would you like to enter the initial configuration dialog? [yes/no]: no

Step 2

Press Return to terminate autoinstall and continue with manual configuration.

Would you like to terminate autoinstall? [yes] Return

Several messages are displayed, ending with a line similar to the following:

...

Compiled date time by person

Step 3

Press Return to bring up the

...

flashfs[4]: Initialization complete.

Router>

Enter privileged EXEC mode.

Step 4

Router> enable

Router#

To avoid losing work you have completed, be sure to save your configuration occasionally as you proceed. Use the

Note

copy running-config startup-config command to save the configuration to NVRAM.

For configuration using the CLI, refer to the applicable configuration procedures in the

Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series

information about accessing this document.

Interface Numbering

Each individual interface (port) on a Cisco 3745 router is identified by number as described in the following sections.

WAN and LAN Interface Numbering

The Cisco 3745 router chassis contains the following WAN and LAN interface types:

• 2 built-in FastEthernet LAN interfaces

• 3 slots in which you can install WAN or voice interface cards

• 4 network module slots

The numbering format is:

• Interface-type Slot-number/Interface-number

Two examples are:

FastEthernet 0/0

The slot numbers are as follows:

• 0 for all built-in interfaces

• 0 for all WIC interfaces

• 1 for the lower-right network module slot

• 2 for the lower-left network module slot

• 3 for the upper-right network module slot

• 4 for the upper-left network module slot

prompt.

Router>

Routers. See the

and

Serial 1/2

Software Configuration Guide:

"Where to Go Next" section on page 24

for