Epson L395 Start Here - Pagina 2

Blader online of download pdf Start Here voor {categorie_naam} Epson L395. Epson L395 4 pagina's.

Carefully seal the bottle using the reverse side of the

bottle tip or screw on the lid for proper disposal.

Replace the ink tank cap securely.

Repeat the previous steps for the remaining bottles.

Close the ink tank cover.

Connect the power cord to the back of the product and to

an electrical outlet.

Caution:

Do not connect to your computer yet.

Raise the control panel and turn on the product. Wait for

the

power light to stop flashing, then follow step 12 to

continue ink charging.

Note:

If all the product lights are flashing, turn off the product

and check that no protective material has been left inside

the product.

Caution:

Do not lower the control panel without first squeezing

the release bar underneath or you may damage the product.

Press and hold the

the

power light starts flashing, to begin charging the

ink. Ink charging takes approximately 20 minutes. Ink

charging is complete when the

flashing.

Note:

The ink bottles included with the printer are designed

for printer setup and not for resale. After some ink is used for

charging, the rest is available for printing.

Caution:

Do not turn off the product or load paper while the

product is charging or you'll waste ink.

Load paper

Make sure the product is not charging. Then flip the

feeder guard forward, raise the paper support, and tilt it

backwards slightly.

Slide the edge guide to the left.

Load paper, glossy or printable side up and short edge

first, against the right side of the rear paper feed slot.

Slide the edge guide against the paper, but not too tightly,

and flip the feeder guard back.

button for 3 seconds until

power light stops

3 seconds

20 minutes