Cisco PIX 506E Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Cisco PIX 506E. Cisco PIX 506E 8 pagina's. Chapter 3
Ook voor Cisco PIX 506E: Snelstarthandleiding (18 pagina's), Snelstarthandleiding (17 pagina's)

Pagina afdrukken

Replacing a Lithium Battery

Figure 3-9

Warning

Danger of explosion exists if the lithium battery is incorrectly replaced. Replace only with the same

or equivalent type recommended by the manufacturer. Dispose of used batteries according to the

manufacturer's instructions.

To replace the lithium battery, perform the following steps:

Remove the chassis cover as described in the

Step 1

Use a flathead screwdriver to slide the battery out of the metal clip on the circuit board (see

Step 2

Place the used battery aside and replace it with a new battery. Install the new battery writing side up.

Step 3

The battery snaps into place as you slide it into the battery slot.

Step 4

Replace the chassis cover by lining up the cover tabs with the bottom panel tabs, and sliding the chassis

Step 5

cover back into the side and front panel slots on the chassis.

Replace the chassis cover as described in the

Step 6

Cisco PIX Security Appliance Hardware Installation Guide

3-8

PIX 506/506E Lithium Battery Location

Battery

"Removing the Chassis Cover" section on page

"Replacing the Chassis Cover" section on page

Chapter 3

PIX 506/506E

3-6.

Figure

3-9).

3-7.

78-15170-02