Cisco Prisma EtherLinX Handleiding voor installatie-instructies - Pagina 14
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Cisco Prisma EtherLinX. Cisco Prisma EtherLinX 38 pagina's.
Pagina afdrukken
Laser Safety,
Continued
Safe Operation For Software Controlling Optical Transmission Equipment
If this document discusses software, the software described is used to monitor
and/or control our and other vendors' electrical and optical equipment designed to
transmit video, voice, or data signals. Certain safety precautions should be observed
when operating equipment of this nature.
For equipment specific safety requirements, refer to the appropriate section of the
equipment documentation.
For safe operation of this software, refer to the following warnings.
WARNINGS:
• Ensure that all optical connections are complete or terminated before using
this equipment to remotely control a laser device. An optical or laser device
can pose a hazard to remotely located personnel when operated without their
knowledge.
• Allow only personnel trained in laser safety to operate this software.
Otherwise, injuries to personnel may occur.
• Restrict access of this software to authorized personnel only.
• Install this software in equipment that is located in a restricted access area.
Laser Safety Information
This laser based multi-mode transceiver is an IEC 60825-1 Amend. 2 Class 1 laser
product. It complies with FDA performance standards (21 CFR 1040.10 and 1040.11)
for laser products except for deviations pursuant to Laser Notice No. 50, dated July
26, 2001.
Note: All adjustments have been made at the factory prior to shipment of the
module. No maintenance or alteration of this device is required. No adjustments or
controls provided.
Class 1 Laser Product
Avoid possible exposure to hazardous levels of invisible laser radiation; do not view
laser aperture.
14
Continued on next page
4008226 Rev B