Cisco TelePresence Server 7010 Handleiding vervangende instructies - Pagina 19

Blader online of download pdf Handleiding vervangende instructies voor {categorie_naam} Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 23 pagina's. 600w ac-input power supply and fan tray replacement
Ook voor Cisco TelePresence Server 7010: Handleiding voor installatie-instructies (15 pagina's), Installatiehandleiding (14 pagina's), Aan de slag (16 pagina's), Handleiding vervangende instructies (18 pagina's)

Pagina afdrukken

Cisco TelePresence Server 7010 Handleiding vervangende instructies

When the system boot is complete, the RP or RSP1 begins to initialize the interface

Step 6

processors. During this initialization, the LEDs on each interface processor behave

differently (most ﬂash on and off). The enabled LED on each interface processor goes on

when initialization has been completed.

•

If the enabled LED on the SP (or SSP) and all interface processors go on, the system

has booted successfully and is now functional.

•

If the RP or RSP1 LEDs previously indicated a successful system boot, but none of the

enabled LEDs on the SP (or SSP) or the interface processors go on, suspect that one of

them has shifted out of its backplane connector and hung the bus. Turn off the power,

then use the ejector levers to release the SP (or SSP) and each interface processor and

reseat them in their slots. (Refer to the section "Moving Processor Modules" on page 14

for removal and insertion steps.) Tighten all captive installation screws, then return to

Step 1.

Step 7

If the enabled LED on a single interface processor remains off, suspect that the interface

processor has shifted out of its slot. Use the ejector levers to release the interface processor

and reseat it in the backplane. (Refer to the section "Moving Processor Modules" on

page 14, for removal and insertion steps.) Tighten both captive installation screws, then

return to Step 1.

If an enabled LED still fails to go on after performing these steps, suspect that the speciﬁc

Step 8

SP (or SSP) or interface processor has failed. Contact a service representative.

Verify that the console terminal displays a script and system banner similar to the

Step 9

following:

GS Software (GS7), Version 10.3(3), SOFTWARE

Compiled Wed 10-May-95 14:46 by mpo

System Bootstrap, Version 4.6(1) [fc2], SOFTWARE

After the system initializes, use the various show commands to display the status of the

Step 10

system and individual interfaces, and ensure that they are operating according to their

previous conﬁguration. (For descriptions and examples of these commands, refer to the

following section, "show Command Descriptions and Examples.")

When the system starts up and operates successfully, the replacement procedure is complete and you

can resume normal operation.

If the system still fails to start up or operate properly, or if you isolate the cause of the problem to a

failed component, contact a service representative for further assistance.

Note

After you verify a successful installation, gather the old chassis and any remaining spares and

parts. If the old chassis is still mounted in a rack, follow the steps in the section "Removing the

Existing Chassis from the Rack" on page 10 to remove it. Place spare interface processors or

interface processor ﬁllers in the chassis slots, and move the chassis to the appropriate location for

storage or shipment.

Cisco 7010 and Cisco 7505 Chassis Replacement Instructions

Replacing the Chassis