Cisco C880 M4 Bedieningshandleiding - Pagina 19

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Cisco C880 M4. Cisco C880 M4 48 pagina's. System event log collection
Ook voor Cisco C880 M4: Handleiding Service Supplement (27 pagina's), Hardware installatiehandleiding (23 pagina's), Snelstarthandleiding (2 pagina's), Handleiding voor firmware-update (5 pagina's)

4.Power Supply

At the defective power supply unit, remove the AC cord clamp and remove the lead.

Figure 11: Ejector levers of a power supply unit

Release the latch of the ejector lever on both sides using both hands, and pull the unit out halfway.

Take the power supply unit out of the bay while supporting its bottom.

Push the new power supply unit into the empty bay halfway while supporting

its bottom.

Open the PSU ejector levers and insert the PSU. Then press the levers fully inward and confirm that

the latches are fastened.

Connect the lead to the power supply unit (see the

AC cord clamp.

Connect the power cable to the mains (see the

Confirm that the Status/Fault LED of the unit shows green light.

section "

Mains Connection

section "

Mains Connection

" on page

28) and set the

" on page

28).