Cisco Expressway CE500 Installatiehandleiding - Pagina 7

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Cisco Expressway CE500. Cisco Expressway CE500 16 pagina's.

Configuring

Before you can use the Cisco Expressway, you must configure its IPv4 and/or IPv6 address, subnet mask

and default gateway. Consult your network administrator for information on which addresses to use. Note

that the Cisco Expressway must use a static IP address.

This section describes how to connect to the Cisco Expressway and perform the initial configuration.

Before you can use the Cisco Expressway, you must configure its IPv4 and/or IPv6 address, subnet mask

and default gateway. Consult your network administrator for information on which addresses to use. Note

that the Cisco Expressway must use a static IP address.

Note: an additional IP address is required if the CIMC (Cisco Integrated Management Controller) tool is used.

It can be a static IP address or assigned via DHCP.

This initial configuration can be done:

by connecting from a PC to the Cisco Expressway using a serial cable (see

[p.8]

followed by

Configuring the Cisco Expressway

by connecting a monitor and keyboard directly into the unit (see

Configuring the Cisco Expressway

if your network is set up to allow it, by connecting using a web browser to the default IP address of

192.168.0.100 (see

Using the web interface

Figure 1: Rear panel showing ports.

The rear panel ports are:

1 VGA port

2 Serial port

3 Dedicated management port (can be used for CIMC in the

future)

4 LAN 1 (left-hand 1-Gb copper port)

5 LAN 2 (right-hand 1-Gb copper port)

Cisco Expressway CE500 Appliance Installation Guide (X8.5)

[p.9]).

[p.10]).

Connecting via the serial port

Connecting via the KVM port [p.9]

followed

Page 7 of 16