Epson Stylus CX3200 Software-installatie - Pagina 11

Blader online of download pdf Software-installatie voor {categorie_naam} Epson Stylus CX3200. Epson Stylus CX3200 20 pagina's. Product support bulletin(s)
Ook voor Epson Stylus CX3200: Specificaties (2 pagina's), Installatiehandleiding (1 pagina's), Start Here (2 pagina's), Productinformatie (12 pagina's), Handmatig (11 pagina's), Update (1 pagina's), Lees dit eerst (2 pagina's), Product ondersteunings bulletin (18 pagina's), Setup (2 pagina's)

Epson Stylus CX3200 Software-installatie
Unplug the Stylus CX and refer servicing to qualified service personnel under the
following conditions: if the power cord or plug is damaged; if liquid has entered the
product; if the product has been dropped or the case damaged; if the product does not
operate normally or exhibits a distinct change in performance. Adjust only those
controls that are covered by the operating instructions.
Before transporting the Stylus CX, make sure the print head is capped in the far right
position, the ink cartridges are in place, and the scanner is secured by the
transportation lock.
This product includes a lamp component that contains mercury. Please consult your
state and local regulations regarding disposal or recycling. Do not put in the trash.

Ink Cartridge Safety Instructions

Leave the ink cartridges installed. Removing the cartridges can dehydrate the print
head and may prevent the EPSON Stylus CX3200 from printing.
Keep ink cartridges out of the reach of children and do not drink the ink.
Be careful when you handle used ink cartridges; there may be ink remaining around
the ink supply port. If ink gets on your skin, wash it off with soap and water. If it gets
in your eyes, flush them immediately with water.
Do not put your hand inside the Stylus CX or touch the cartridge during printing.
Do not move the print head by hand; otherwise you may damage the Stylus CX.
Install the ink cartridge immediately after you remove it from its package. Leaving the
cartridge unpacked for a long time before use may result in reduced print quality.
Do not use an ink cartridge beyond the date printed on the cartridge package. For
best results, use up the ink cartridges within six months of first installing them.
Store ink cartridges in a cool, dark place. Store each ink cartridge so that the bottom
of its package faces down.
After bringing an ink cartridge inside from a cold storage site, allow it to warm up at
room temperature for at least three hours before using it.
Do not remove or tear the label or shake an ink cartridge; this can cause leakage.
Do not dismantle the ink cartridges or try to refill them. This could result in damage
to the print head.
Do not touch the green IC chip on the side of the cartridge. This may affect normal
operation and printing.
9