Motorola CD303 Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Motorola CD303. Motorola CD303 48 pagina's.

1. Plug the power adaptor into the socket marked

the other end into the mains power wall socket.

2. Remove the battery cover from the back of the handset and insert the 2 x AAA NiMH

rechargeable batteries supplied. Please note the '+' and '-' markings inside the battery

compartment and insert in the

correct direction.

3. Slide the battery cover back into place.

4. If you are charging the batteries for the first time, place the handset on the charger to

charge for at least 24 hours continuously.

5. When the handset is fully charged,

display will show

to the base.

IMPORTANT

Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA Ni-MH 750mA

rechargeable batteries) supplied with your CD3.

Please do not use alkaline or nonrechargeable batteries. It may cause permanent

damage to the product and void the warranty.

BATTERY LOW WARNING

If you hear a warning beep every 30 seconds during a call, you will need to recharge the

handset before you can use it again.

When charging,

BATTERY PERFORMANCE

In ideal conditions, fully charged batteries should give up to 10 hours talk time or up to 150

hours standby time on a single charge.

Note that new batteries do not reach their full capacity until they have been put to normal

use for several days.

To keep your batteries in the best condition, leave the handset off the base for a few hours

at a time.

Running the batteries right down at least once a week will help them last as long as

possible.

The charge capacity of rechargeable batteries will reduce with time as they wear out,

giving the handset less talk / standby time. Eventually they will need to be replaced.

After charging your handset for the first time, subsequent charging time is about 6–8 hours

a day. Batteries and handset may become warm during charging. This is normal.

All talk and standby times are approximate and depend on features selected and usage

pattern.

Getting started

HANDSET

and handset number (e.g. 2) to indicate that it is registered

icon will scroll on the display. Once charged scrolling will stop.

on the rear of the charger and plug

icon will appear steady on the display. The