Motorola CP160 Gebruikershandleiding - Pagina 30

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Motorola CP160. Motorola CP160 46 pagina's. Uhf2 (438-470mhz)
Ook voor Motorola CP160: Basis gebruikershandleiding (16 pagina's), Basis gebruikershandleiding (16 pagina's), Basis gebruikershandleiding (18 pagina's), Gedetailleerde servicehandleiding (28 pagina's), Cps/Tuner Installatiehandleiding (6 pagina's), Service-informatie (46 pagina's), Service-informatie (46 pagina's)

Pagina afdrukken
Motorola CP160 Gebruikershandleiding

STOP SYSTEM SCAN

Press the preprogrammed Scan button to stop
System Scan.
– or –
J
1
to enter menu mode.
L
M
2
or
until
J
3
to select
The display shows the current scan status.
L
M
4
or
until
J
5
to select the current setting.
The Gsymbol disappears from the
•
display.
Note: Your dealer/programmer can preprogram
your radio when exiting System Scan to
automatically revert to the last scan channel
that had activity on it or to automatically
revert to the channel where scan was
initiated.
English
28

START AUTO SCAN

Auto Scan automatically starts scanning once a
channel with Auto Scan enabled is selected.
Select a channel that has been preprogrammed for
Auto Scan by your dealer/programmer.

STOP AUTO SCAN

SYS SCAN
Select a channel that has not been preprogrammed
SYS SCAN
for Auto Scan by your dealer/programmer.
The Gsymbol disappears from the display.
•
SCAN OFF

TALKBACK

The Talkback feature allows you to respond to a
transmission while scanning. If transmission is
detected on a channel while scanning, the radio will
stop on that channel for a default period of time
after activity has ceased. This is referred to as
"hangtime". During this hangtime you may respond
by pressing the PTT button.
Note: The LED scan indicator stops blinking while
the radio is in hangtime. If the PTT button is
not pressed after the preprogrammed
hangtime, the radio returns to scanning
channels.