Toshiba 24 WL1A Series Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Toshiba 24 WL1A Series. Toshiba 24 WL1A Series 30 pagina's.

Pagina afdrukken

(*) Default PIN could have been set to 0000 or 1234. If you

have defined the PIN(is requested depending on the country

selection) during the First Time Installation use the PIN

that you have defined.

3. Settings

You can manage the settings of your TV using the op-

tions of this menu. Refer to Settings Menu Contents

section for more information.

4. Sources

You can manage your input source references using

the options of this menu. To change the current source

highlight one of the options and press OK.

4.1. Source Settings

Edit the names, enable or disable selected source

options.

Inserting the Batteries into the Remote

Remove the back cover to reveal the battery

compartment. Insert two size AAA batteries. Make

sure the (+) and (-) signs match (observe correct

polarity). Do not mix old and new batteries. Replace

only with same or equivalent type. Place the cover back

on. A message will be displayed on the screen when

the batteries are low and must be replaced.

Note that when the batteries are low, the performance

of the remote control may be impaired.

Power Connection (Optional)

IMPORTANT: The TV set is designed to operate on

a 12 V DC supply. For this, an adaptor is used which

gives 12 V voltage. Connect this adaptor to a system

that supplies 100-240V AC, 50/60Hz.

After unpacking, allow the TV set to reach the ambient

room temperature before you connect the set to the

mains. Plug the adaptor to the mains socket outlet.

AC adaptor

Power Input, DC 12 V terminal

In order to supply the power via the cigarette lighter

socket of your vehicle, plug one end of the supplied

cigarette lighter adaptor cable into the vehicle socket

and plug the other end of the adaptor cable into the

DC 12V terminal on the back side of the TV.

Important safety information

Be sure to ground the connection

Connect the ground terminal of the AC

adaptor with the ground terminal provided at

the power outlet using the enclosed power

cord. If the provided plug does not fit your

outlet, consult an electrician for replacement

Surely connect the ground wire.

Power Connection

IMPORTANT: The TV set is designed to operate on a

220-240V AC, 50 Hz supply. After unpacking, allow the

TV set to reach the ambient room temperature before

you connect the set to the mains. Plug the power cable

to the mains socket outlet.

Antenna Connection

Connect the aerial or cable TV plug to the AERIAL

INPUT (ANT.) socket or satellite plug to the SATELLITE

INPUT (LNB) socket located on the rear side of the TV.

Rear side of the TV

Satellite

Aerial or cable

If you want to connect a device to the TV, make sure

that both the TV and the device are turned off before

making any connection. After the connection is done,

you can turn on the units and use them.

English - 6 -

properly

of the obsolete outlet.