Whirlpool UXT4236ADS0 Installatie-instructies en gebruiks- en onderhoudshandleiding - Pagina 6
Blader online of download pdf Installatie-instructies en gebruiks- en onderhoudshandleiding voor {categorie_naam} Whirlpool UXT4236ADS0. Whirlpool UXT4236ADS0 28 pagina's. 30" (76.2 cm) and 36" (91.4 cm) range hood
Pagina afdrukken
NOTES:
INSTALLATION
Depending on your model, determine which venting method
to use: roof, wall or non-vented
(recirculating).
•
It is recommended
that the vent system be installed before
the range hood is installed. Go to "Venting System" in the
"Installation
Requirements"
section if you need assistance.
•
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for the vent system.
1. Disconnect
power
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
2. Mark Hole Locations
Align the exterior edge of the mounting brackets with the exterior
edges of the upper cabinet.
IMPORTANT: The brackets should touch the upper cabinet.
With a pencil, mark the upper holes on the brackets.
INSTRUCTIONS
3. Install Brackets
•
Using a #2 Phillips screwdriver, install the drywall anchors.
•
Using #8-18 x 1" (4.2 x 25 mm) flat-head #2 Phillips screws,
install the mounting brackets using the upper holes.
NOTE: For installations to a surface other than drywall, it is
recommended
that a qualified contractor determine the
anchoring method.
4. Prepare
Range
Hood
•
Set the range hood on its back on a covered surface.
•
Using a #2 Phillips screwdriver, remove the rectangular
damper attached with 3.5 x 9.5 mm screws.
•
Using a #2 Phillips screwdriver, remove the electrical box
cover.
•
Using a flat-blade screwdriver, remove the appropriate
power
supply knockout.
6