Whirlpool WT9BTABC Handmatig - Pagina 10

Blader online of download pdf Handmatig voor {categorie_naam} Whirlpool WT9BTABC. Whirlpool WT9BTABC 19 pagina's.

9. Put the cooker hood on the hook. See FIG 8.

(FIG 8)

10. Fix the body with 2pcs ST4*30mm safety screw. Note: The two safety vents are positioned on the

back housing, with diameter of 6mm. And then adjust the height of the inside chimney to the

position of inside chimney bracket and fix on it by screw(ST4*8mm). See FIG 9 & FIG 10.

Hints for Exhaust Duct Installation

The following rules must be strictly followed to obtain optimal air extraction result:

 Keep expansion pipe short and straight.

 Suggest to use φ 150*2m expansion pipe for the best performance.

 When installing expansion pipe, always pull it tight to minimize loss on hood efficiency caused by

pressure.

 Failure to observe and follow these instructions, cooker hood performance will be reduced and

noise level will be increased.

 Installation work must be carried out by a qualified electrician or competent person.

 Do not connect the ducting system of the hood to any existing ventilation system which is being

used by any other appliances, such as warmer tube, gas tube, hot wind tube.

 The angle of the bend of the expansion pipe should not less than 120°; you must direct the pipe

horizontally, or, alternatively, the pipe should go up from the initial point and led to an outer wall.

 After the installation, make sure that the cooker hood is level to avoid grease collection leak out

from one end. See FIG 11.

 Ensure the expansion pipe selected for installation complies with relevant standards and is fire

retardant.

inside chimney

outside chimney bracket

outside chimney

(FIG 6)

(FIG 9)

expansion pipe

V-flap

FIG 7)

(

(FIG 10)