Alderon Industries Vizzyalarm VZW-02 Bedienings-, onderhouds- en installatiehandleiding - Pagina 5

Blader online of download pdf Bedienings-, onderhouds- en installatiehandleiding voor {categorie_naam} Alderon Industries Vizzyalarm VZW-02. Alderon Industries Vizzyalarm VZW-02 6 pagina's.

Alderon Industries Vizzyalarm VZW-02 Bedienings-, onderhouds- en installatiehandleiding
Vizzyalarm™ 1-Zone WiFi Alarm Panel - Installation Instructions
Connecting the Alarm Panel to WiFi Network
Once all the steps of the wiring, installation, and testing are completed, the alarm panel is ready to be connected and
registered to the Alderon™ cloud based Vizzy.site™ to begin monitoring and receiving text and email alerts for system
conditions. Choose your preferred method of connecting the alarm panel to a WiFi network, either WPS or HTTP. See below
for instructions on how to setup the network connection and an example of connecting using a mobile phone (step 1b).
1a. WPS Mode:
Press and hold the WiFi/connect pushbutton for more than
5-seconds or until the blue WiFi LED flashes slowly (Fig. 15).
Then, release the WiFi/connect pushbutton and press the WPS
button on the router to pair the device with an IP address.
Note: Once the alarm panel has been placed into the WPS mode, there is
approximately 2-minutes to establish a connection with the router before the
WPS settings mode times out. After the connection has been established
and the WiFi LED turns solid (Fig. 19), skip to page 6 step 1 if using a WPS
connection to register the device.
1b. HTTP Mode:
Press and hold the WiFi/connect pushbutton for less than
5-seconds or until the blue WiFi LED flashes quickly (Fig. 16).
Then, release the WiFi/connect pushbutton and use a mobile
phone, laptop, or computer that is within range of the alarm
panel to pair the device with an IP address.
Note: Once the alarm panel has been placed into the HTTP mode, there
is approximately 2-minutes to establish a connection with the preferred
electronic device before the HTTP settings mode times out. See connection
example below.
Switch Mode Type: If you are in either WPS or HTTP mode and wish to cancel
the current settings mode, press the WiFi/connect pushbutton for approximately
1-second to start over. The alarm panel default setting for a canceled connection
function is HTTP mode (less than 5-second press and hold), with the blue WiFi LED
flashing quickly (Fig. 16).
Connection Example with Mobile Phone:
Prior to registering the device (page 6 step 1) using HTTP mode,
you must first connect the alarm panel. Once the alarm panel has
been placed into HTTP settings mode with the blue WiFi LED
flashing quickly (Fig. 16):
i. Go into the mobile phone settings, click/tap on WiFi network
ii. Locate the Vizzy™ device model with ID, then click/tap to
sign-in (Fig. 17)
iii. The available networks should display on the Vizzy.site™
web page, click/tap on preferred network (Fig. 18)
iv. Enter the network name and password, then click/tap the
Connect button to connect the Vizzy™ device to the preferred
network (Fig. 18)
v. The blue WiFi LED should switch from a quick flash (Fig. 16)
to solid, indicating the Vizzy™ device is connected to an IP
address (Fig. 19)
Alderon Industries, LLC - Leading Edge Control Products | 218.483.3034 | [email protected] | [email protected] | alderonind.com
(Fig. 15)
(slow flash)
(Fig. 16)
(quick flash)
(Fig. 17)
(Fig. 19)
(solid)
Installation Instructions | Page 5
(5+ seconds)
(0.5 - 5 seconds)
(Fig. 18)