Zanussi ZFG06400WA Gebruikershandleiding - Pagina 10
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZFG06400WA. Zanussi ZFG06400WA 12 pagina's.
Ook voor Zanussi ZFG06400WA: Gebruikershandleiding (12 pagina's)
Pagina afdrukken
Door reversibility
The side at which the door opens can be
changed from the left side to the right side (as
supplied), if the installation site requires
Warning!
When changing the side at which the door
opens, the appliance must not be connected
to the mains Remove plug from the mains
beforehand
1
4
1. Screw
2. Low hinge
3. Upper hinge
4. Adjustable low foot
5. Adjustable high foot
6. Screw bolt
7. Plug
8. Decoration block
9. The block of the top cover
10. Top cover plate
11. Screw nail
10
ZANUSSI_ZFG06400WA_Hungary.indd 10
11
6
10
5
7
9
8
2
3
1. Remove the screw nails (11)
2. Keep the door open, raise the end of the top
cover, push it (10) frontad and take it off from
the block (9) of the top cover, then move the
bottom block (8)
3. Remove the two screws blot (6) that connect
the upper hinge (5) on the right side of the
cabinet top
4. Carefully lift the door and place it on a pad-
ded surface to prevent scratching
5. Remove the plug (7) and transfer it to the
uncovered hole on the right side of the unit
Be sure to press the button firmly into the
hole
6. Remove the two screws (6) that hold the
lower hinge (2) on the right side of the unit
7. Remove the screw-type leveling front leg (4)
and transfer it to the right side as shown in
the adjacent figure.
8. Set the door into it's new place making sure
the pin enters the bushing at the lower frame
section (hole)
9. Secure the upper hinge (5) previously
removed in step 3 on the left side of the unit
Make sure the pin enters the bushing on the
upper frame section (hole)
10. Loosely secure the lower left hinge (2) and
do not tighten the bolts until the door is in
the closed position and leveled
11. Insert the plug (7) on the uncovered holes
(right side)
12. Fix the decoration block (8) in the right of the
top cover plate (10)
13. Keep the door open, raise the end of the
top cover, pull it (10) backwards to hitch the
block (9)
14. After the assembly of the top cover, close
the door, fix the top cover (10) with the
screw (11)
www.zanussi.com
4/1/2015 3:30:01 PM