Zanussi ZCG43050WA Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZCG43050WA. Zanussi ZCG43050WA 29 pagina's.

Pagina afdrukken
COOKER CONTROL PANEL
1
2
ACCESSORIES
•
Wire shelf
For cookware, cake tins, roasts.
•
Grill- / Roasting pan
To bake and roast or as pan to collect fat.
•
Trivet

BEFORE FIRST USE

WARNING! Refer to Safety chapters.

INITIAL CLEANING

Remove all accessories and removable shelf
supports from the oven.
Refer to "Care and cleaning" chapter.
Clean the oven and the accessories before the first
use.
Put the accessories and the removable shelf
supports back to their initial position.
PREHEATING
Preheat the empty appliance before first use.

HOB - DAILY USE

WARNING! Refer to Safety chapters.
IGNITION OF THE HOB BURNERS
Always light the burner before putting
on the cookware.
WARNING! Be very careful when you
use open fire in the kitchen
environment. The manufacturer
declines any responsibility in case of
the flame misuse.
1. Turn the knob for the hob to the position
and push it down. When you push the knob,
the spark generator activates automatically.
10
1
2
2
3
3
1. Set the maximum temperature.
2. Let the appliance operate for 1 hour.
3. Set the function
4. Let the appliance operate for 15 minutes.
Accessories can become hotter than usual. The
appliance can emit an odour and smoke. This is
normal. Make sure that the airflow is sufficient.
2. Keep the knob for the hob pushed for equal or
3. Adjust the flame after it is regular.
Knob for the top oven
Knobs for the hob
Knob for the main oven
For roasting and grilling.
Use the trivet only with the Grill- /
roasting pan.
Preheat the two ovens. Heat up one
oven at a time.
.
less than 10 seconds to let the thermocouple
warm up. If not, the gas supply is interrupted.
WARNING! Do not keep the knob
pushed for more than 10 seconds. If
the burner does not light after 10
seconds, release the knob, turn it into
the off position and try to light the
burner again after minimum 1 minute.
If after some tries the burner does not
light, check if the crown and its cap
are in the correct position.