3Com NBX V3000 Analog Instructieblad

Blader online of download pdf Instructieblad voor {categorie_naam} 3Com NBX V3000 Analog. 3Com NBX V3000 Analog 2 pagina's. Ip telephony solution
Ook voor 3Com NBX V3000 Analog: Release Release (8 pagina's), Release Release (11 pagina's), Upgrade-informatie (2 pagina's), Snelle referentiehandleiding (2 pagina's), Release Release (4 pagina's), Gegevensblad (4 pagina's)

Pagina afdrukken

This instruction sheet explains how to replace a disk drive on an NBX V3000 Networked Telephony Solution.

CAUTION: Always wear a properly grounded anti-static strap when you remove the cover from the NBX V3000

system.

To replace an NBX V3000 disk drive:

If you are able to access the NBX NetSet™ utility, perform a data backup and a license backup. Use the

administrator login to open the NBX NetSet utility, and then click Operations > Manage Data.

Be sure to backup both data and licenses. These are separate procedures. Also make sure you have

available the .taz file for the version of NBX system software you are running.

If the system is running, shut down the NBX V3000 system software:

Use the administrator login to open the NBX NetSet utility, and then click

Operations > Reboot/Shutdown.

Click Shutdown, and then wait a moment for the message that verifies that it is safe to turn the power off.

CAUTION: You must shut down the system software before you remove power from the

NBX V3000 system to avoid file corruption problems.

Turn off the power switch on the back of the NBX V3000, and then disconnect the power cord.

If necessary, remove the NBX V3000 from the rack, and then remove the two rack mounting brackets

from the NBX V3000.

Remove the nine screws (three from each side and three from the back) that secure the top cover of the

NBX V3000.

Slide the cover slightly to the rear of the unit, and

then lift the cover off.

Remove the disk drive assembly from your

NBX V3000. See Figure 1.

Remove the ribbon connector 1, and discard

it. The replacement disk drive kit includes a

new ribbon connector.

Remove the power connector 2, and the

jumper cable connector 3, from the disk drive

assembly. Take note of how each connector is

keyed to its connection.

Remove the two screws 4, that hold the disk

drive assembly to the chassis.

Lift the disk drive assembly from the four

brass corner clips that hold it to the chassis.

You must pull up firmly until the disk drive

assembly pops free from the corner clips.

Remove the four screws that hold the circuit

board to the old disk drive. See Figure 2.

The disk drive circuit board hosts firmware that validates your system licenses. Your disk drive circuit

board must remain with your chassis.

EPLACING THE

ISK

RIVE

3C10118A — NBX V3000 Disk Drive Replacement

NBX

Figure 1 NBX V3000 Internal Components

V3000