Arnica UT64010 Handleidingen - Pagina 13

Blader online of download pdf Handleidingen voor {categorie_naam} Arnica UT64010. Arnica UT64010 17 pagina's.

ENERGY SAVING

V. IMPORTANT - CLEANING AND MAINTENANCE

ECO mode

By using ECO mode reduced the amount of steam, you can save energy without

compromising on the ironing result.

1. To activate the ECO mode, press and hold the on/off button for 2 seconds.The light turns blue.

2. To switch back to the *OptimalTemp* setting, switch the steam generator off and on again.

Safety Auto-off (specific types only)

The SafetyAuto-off function automatically switches off the appliance if it has not been used

for10 minutes, to save energy.

To ensure a Iong Iife for your steam generator, it is very important that you perform the

descaling procedure when the EASY DE-CALC light starts to flash.

-The Easy DE-CALC light starts flashing after a total of 8 working hours to indicate that The

steam generator needs to be descaled. To descale the steam generator perform the steps

below. Never remove the EASY DE-CALC knob when the steam generator is hot

1. Press the on/off button to switch off the steam generator and remove the plug from the

wall socket.

2. Place the steam generator on a stable table with the EASY DE-CALC knob sticking out

beyond the edge of the table or take the steam generator to a sink.

3. Hold a cup under the EASY DE-CALC knob. Turn the EASY DE-CALC knob anti-clockwise

and Let the water with scale particles flow into the cup.When no more water comes out of

the steam generator, reinsert the EASY DE-CALC knob.Turn the knob clockwise to fasten it

and put the plug back into the socket again. You can now use the steam generator again.

Clean the soleplate regularly to remove stains from the soleplate.

-To maintain a good gliding of your soleplate, it is recommended to clean it regularly (once every

2 months). You can do that by heating up the iron and moving the soleplate over a moist fabric.

-Descaling the soleplate: if you do not descale your steam generator regularly, scale may

build upon the soleplate.you can remove scales by following the instructions below:

1.Descale the steam generator before you clean the soleplate (see section *IMPORTANT

- Descaling the steam generator).

2. Tilt the steam generator and pour 500ml distilled water into the opening. Reinsert the

EASY DE-CALC knob and turn the knob clockwise to fasten it.

3. Press the on/off button and wait for 5 minutes.

4. Put a piece of thick cloth on your ironing board. Place your iron on the cloth, press and

hold the steam trigger.While pressing the steam trigger, slowly move the iron back and forth

across the cloth until no water comes out anymore or when steam comes out.

Hot Dirty water comes out of the soleplate.

5. Switch offthe steam generator and Iet it cools down for 2 hours.

6.Remove the EASY DE-CALC knob and Iet the water flow into a cup. Reinsert the EASY

DE-CALC knob and turn the knob clockwise to fasten it.

7. Repeat steps 2 to 6 of this cleaning procedure.