ARO 7744-15 Gebruikershandleiding
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ARO 7744-15. ARO 7744-15 8 pagina's. Power motor
OPERATOR'S
MANUAL
Tool Products
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
50 SERIES POWER MOTOR
Released:
8-1-89
Revised: 10-6-95
Form:
3507-2
Models 7744-l 0 and 7744-l 5
WARNING
READ THIS MANUAL
CAREFULLY
BEFORE INSTALLING,
OPERATING
OR SERVICING
THIS EQUIPMENT.
FAILURE TO OBSERVE
THE FOLLOWING
WARNINGS
COULD RESULT IN INJURY.
Pneumatic tools should always be installed and used in accor-
dance with A.N.S.I. B186.1 "Safety Code For Portable Air Tools."
0
l
l
l
l
l
l
Operate this tool at 90 p.s.i.g. (6.2 bar) maximum air pressure
at the air inlet of the tool.
Disconnect air supply from tool before removing/installing
bit,
socket or device attached to tool or performing maintenance
procedures.
Keep hands, clothing and long hair away from rotating end of
tool.
Anticipate and be alert for sudden changes in motion during
start up and operation of any power tool.
Never exceed rated r.p.m. of tool.
Wear suitable eye and hearing protection while operating tool.
Tool shaft can continue to rotate briefly after throttle is re-
leased.
Do not lubricate tools with flammable orvolatile liquids such as
kerosene, diesel or jet fuel.
Do not remove any labels. Replace any damaged label.
Use only accessories
recommended
by ARO.
Repeated prolonged operator exposure to vibrations which may
be generated in the use of certain hand-held
tools may produce
Raynaud's
phenomenon,
commonly
referred to as Whitefinger
disease.
The phenomenon
produces
numbness
and burning
sensations in the hand and may cause circulation and nerve dam-
age as well as tissue necrosis.
Repetitive
users of hand-held
tools who experience
vibrations should closely monitor duration
of use and their physical condition.
l
The use of other than genuine ARO replacement
parts may
result in safety hazards, decreased tool performance
and in-
creased maintenance
and may invalidate all warranties.
l
ARO is not responsible
for customer modification of tools for
applications
on which ARO was not consulted.
l
Tool maintenance
and repair should be performed by autho-
rized, trained, competent
personnel.
Consult your nearest
ARO authorized servicenter.
It is the responsibility
of the employer to place the information
in this manual into the hands of the operator.
For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand
Distribution
Center, White House, TN at PH: (615) 672-0321,
FAX: (615) 672-0801.
ARO Tool Products
Ingersoll-Rand
Company
1725 U.S. No. 1 North • P.O. Box 8000
l
Southern Pines, NC 2838843000
©1995 THE ARO CORPORATION.
PRINTED
IN U.S.A.
Part of worldwide Ingersoll-Rand