3DHobbyShop.com Yak 54 Montagehandleiding - Pagina 7
Blader online of download pdf Montagehandleiding voor {categorie_naam} 3DHobbyShop.com Yak 54. 3DHobbyShop.com Yak 54 18 pagina's. 55” arf rc aircraft
Pagina afdrukken7
Locate the rudder. Measure 2 inches back from the front hinge line on the bottom of the rudder, and drill
a 1/16 " hole on the bottom. Using CA or epoxy glue, glue the tailwheel tiller keeper into the bottom of
the rudder as shown. NOTE: The tailwheel keeper is the same part as the rudder pull-pull cable ends.
Locate the slot in the rudder for the rudder control horn, remove the covering over the slot, and glue the
control horn into the rudder as shown with medium and thin CA, using the same procedure as for the
aileron horns. Test fit the horn before applying CA glue, as you did before.
Slide the rudder into the rear of the fuselage/vertical stabilizer and use two large drops of CA glue on
each rudder hinge. Slide the tailwheel tiller wire into the tiller wire keeper on the rudder, and use two
wood screws to attach the tail-wheel bracket to the bottom of the fuselage as shown.