3DR LiveView Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} 3DR LiveView. 3DR LiveView 2 pagina's. Kit for gopro

Pagina afdrukken

IRIS+ Mounting

Choose a position on the shell to mount the video transmitter, and

attach the second piece of velcro there. You can mount the transmitter

anywhere on the shell where it will not obstruct the propellers or interfere

with the battery door. We recommend placing it between the gimbal

interface place and the battery door; make sure to place it close enough

to the gimbal plate so that the battery door can fully open.

Locate the gimbal power cable on the underside of IRIS, and disconnect

the two red connectors. This is where you will connect the splitter cable

to power both the gimbal and the video transmitter off the flight battery.

IRIS: Disconnect gimbal power cable

Connect the splitter cable to both red connectors. The splitter cable

should now be connected to (1) the red connector on the gimbal power

cable, (2) the red connector on the IRIS power cable, and (3) the video

transmitter. Secure the two velcro strips together.

Monitor Assembly

The monitor mounting bracket includes extra parts for attaching to

different controllers.

Use for this assembly.

Mounting bracket parts

Insert the larger black screw into the hinge between the two silver

parts. Then position the bracket over the neck-strap attachment

on the controller, and insert the smaller black screw.

(2.5 mm hex key)

(2 mm hex key)

Controller and mounting bracket assembly

Add both ground antennas (blue) to the monitor. Add the black

washer to the silver screw, and attach the monitor to the bracket.

Recommended placement of mounting

velcro on IRIS

Extra parts

Complete controller and monitor assembly

Splitter

cable

IRIS, video transmitter, and gimbal:

complete wiring

X8+ Mounting

Attach the second piece of velcro in front of the Pixhawk where the video

transmitter can connect to both the power and GoPro video cables.

Connect the red connector on the X8 to the larger red connector on

the splitter cable. (The splitter cable's smaller red connector will remain

unconnected.) Secure the two velcro strips together.

X8 and video transmitter: complete wiring

Operation

Power the copter, controller, gimbal, and GoPro normally. Press and

hold the power button to turn on the monitor.

Power

Mode

Monitor

To configure the monitor, set the mode to DIV (M button changes modes),

the channel to 8 (+ and - buttons), and the band to E (press the power

button to access the menu, the M button to advance within the menu, and

the up and down arrow buttons to make individual selections).

Video Transmitter Specs

5.8 GHz 200 mW wireless AV transmitter:

Transmitter frequency / channel amount: 5705-5945 MHz / 8 CH

Output power: 200 mW/33 dBm

Frequency control: Built-in frequency & phase lock loop

AV input: analog AV signal input

ANT connector: RP-SMA

Power supply: DC 7-12 volts

Current supply: 850 mA

Size: 68*26*28 mm

Weight: 60 g (including antenna)

Gross weight: 85 g

IRIS LiveView complete assembly

X8 and video transmitter: complete assembly

Down

Minus

Plus