3DUpFitters CR-10 S4 Installatiehandleiding - Pagina 9

Blader online of download pdf Installatiehandleiding voor {categorie_naam} 3DUpFitters CR-10 S4. 3DUpFitters CR-10 S4 15 pagina's. Enclosure kit

The air ﬁlter should look like this after being

attached. Note that its easier to insert the

screws from the inside, and put the nuts next to

the ﬁlter housing.

Now attach the back to the assembled left

and front panels, which should look like the

illustration to the right.

5. Attach Top

Be careful taking oﬀ the protective cover,

as the top is delicate in the area of the slit

in the middle.

Use access through the doors to attach the

top of the enclosure using M4 12mm screws.

The hole to feed through ﬁlament in the stock

conﬁguration will be on the left-back side of

the top, shown circled in red.

If you are using a top feeding conﬁguration the

ﬁlament will be fed through the slit in the

middle.