artisan Altivar ATV-16U41N4 Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} artisan Altivar ATV-16U41N4. artisan Altivar ATV-16U41N4 17 pagina's. Speed controller for asynchronous motors
Pagina afdrukken
Technical characteristics
Output voltage
Frequency range
Overtorque
Acceleration ramp
Deceleration ramp
Low speed braking
to a standstill
Speed controller
protection
Motor protection
Degree of protection NEMA 1, IP 30 (remove cover), for ATV-16U09M2 to U72N4
Ambient air
U72N4.
temperature
E
N
G
Maximum humidity
L
I
S
Altitude
H
Pollution
Standards /Certification / IEC, VDE, UL, CSA.
Recommendation
Installation : Mounting recommendations
IP30 : Remove the blanking plate from the top
of the cover. Free space is required around
the speed controller : D
IP30
Nema 1
d
18
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Maximum voltage equal to supply voltage.
0.1 Hz to 50 Hz / 60 Hz.
150 % of motor rated torque (typical value ± 5 %, from 5 to 50/60 Hz).
Linear 3s from 0 to 50 Hz / 60 Hz (automatic adaptation of ramp times
when transient torque is exceeded).
By automatic d.c. injection 0.7 In, for 0.5s if the frequency
drops to < 0.1Hz.
Supply overvoltage / undervoltage.
Phase failure : only for ATV-16...N4.
Short circuit : between output phases, between output phases and ground,
internal control supplies (+10, +24).
Overvoltage / Over heating
Thermal : I
2
.t if rated motor current = 0.9 In (rated current) of the speed controller
(from 25/30 to 50/60 Hz).
IP 30 for ATV-16U90N4.
Operating : 0 to 40°C for NEMA 1/ 0 to 50°C for IP 30, for ATV-16U09M2 to
0 to 40°C in IP 30 for ATV-16U90N4 – 0 to 50°C in IP 30 with mandatory use
of inductance VW3-A66503.
Storage : -25°C to + 70°C.
93 % without condensation or dripping water (if there is a risk of condensation
provide a heating system).
Less than 1000 m. Above that, derate power by 3% for each additional 1000 m.
Speed controller protected against dust, corrosive gas, water splashes, etc.
≥
≥
100 mm, d
50 mm.
D
Mount the unit vertically
Avoid placing close to any heating
equipment.