Asko T720 Gebruiks- en onderhoudshandleiding - Pagina 10
Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Asko T720. Asko T720 16 pagina's. User manual use & care guide t760-t780 (use & care guide - en, fr)
Ook voor Asko T720: Snelstarthandleiding (2 pagina's), Installatie (1 pagina's)
Pagina afdrukken
INST
INSTALLA
ALLATION INSTR
TION INSTRUCTIONS
Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualified person who is familiar with all
local codes and ordinances for electrical and plumbing
connections.
SPECIFICATIONS
SPECIFICA
TIONS
Height
33-1/2"–34-1/2 (850–876 mm)
Width
23-7/16" (595 mm)
Plus exhaust hose connection
Depth
T760/T780: 23-7/16" (595 mm)
T700/T720: 24-7/16" (620 mm)
Weight
86 lbs (39 kg)
Drum material
Stainless Steel
CONNECTING AIR EXHA
CONNECTING
AIR EXHAUST (T700
The exhaust hose can be connected at the rear or on
either side of the dryer. When the machine is delivered,
the exhaust outlet at the rear is open.
Side Exhaust Outlet
The dryer is shipped with a stub pipe already installed
on the rear exhaust outlet. The consumer or installer
must purchase a UL-CSA-approved exhaust hose.
Rear Outlet Hose Connection
To connect the exhaust hose to the rear outlet, follow
the steps below:
1. Push the hose onto the stub pipe and secure it with
a clamp.
2. With the hose attached, insert the stub pipe into the
hole. It should snap into place.
NOTE: After you push the dryer into place, check for
kinks in the hose. (Be careful not to use too
much hose.)
CONDENSATION DRAIN CONNECTION (T720
CONDENSA
TION DRAIN CONNECTION (T720 AND
If possible, you should install the dryer so the
condensed water will continuously flow into a drain or
sink. To do this, follow the instructions below:
1. Disconnect the short hose (1) from the blue
connection. (It's okay to let the hose hang down.)
2. Connect the rubber hose supplied with the dryer to
the blue nipple (2).
3. Run the hose to a drain or sink, as illustrated.
NOTE:
The drain hose must not be more
than 40" above the floor.
Page 10
UCTIONS
UST (T700 AND
The exhaust hose
can be connected at
the rear or on either
side of the dryer.
Rear Exhaust Outlet
Stub
Clamp
Hose
(not supplied)
NOTE:
Cosmetic damage must be reported to your
dealer within five days from the date of
purchase. After unpacking the dryer, thoroughly
check the unit for cosmetic damage.
Outer casing
Stove-enamelled hot-dipped
galvanized steel
Power requirement 2800 watts
For connection
Single-phase, 230 V, 30 Amp
Internal fuse
15 amp.
Heating element
2500 watts
AND T760)
T760)
Connecting the Vent Hose to the
Left or Right Side Outlet
To connect the exhaust hose to the left or right side
outlet, follow the steps below:
1. Using a flathead screw-
driver, turn the exhaust
outlet cover to align the tabs
holding the cover in place.
Remove the cover.
2. Remove the stub pipe from
the rear exhaust outlet.
3. Place the stub pipe in the
outlet you plan to use.
4. Follow the instructions for the rear outlet hose
connection.
5. Use the exhaust outlet cover you removed from the
side to cover the rear exhaust outlet.
WARNING!
To reduce the risk of fire, this appliance must be
exhausted OUTDOORS or the equivalent.
Never cover the end of the dryer stub or vent hose
with anything to catch lint, except for UL approved
vent basket.
AND T780)
T780)
Back of dryer
Vent
T-Tube