REMOVING THE TOE KICK BRACKETS
To remove the toe kick brackets, hold the small metal
spring tab on the outer edge of the base pan toward the
outside of the machine. Continue holding the tab as
you pull straight out on the bracket. (Note: It may be
stubborn because it's in guide slots on the base pan.)
See page 10 for instructions on how to adjust the toe
kick brackets.
REMOVING THE GUARD PLATE
If the cord is not long enough, or if a hard-wire
installation is needed, you will need to remove the guard
plate to complete the electrical connection.There are
four 20 torx or flathead screws that hold the guard plate
in place, two on the upper/underneath side and two on
the front.
Guard plate
To remove the guard plate, first remove the toe kick
brackets (see this page). Then remove the two screws
on the upper/underneath side of the guard plate. Next,
remove the two screws from the front side of the guard
plate.
MOVING THE MACHINE INTO PLACE
WARNING!
Make sure you put the protective slides on the rear
legs to prevent damaging the floor when you slide the
unit into place (see page 6).
1.
Position the machine in front of the cabinet
opening.
2.
Make the height adjustment while the dishwasher
is in front of the opening.
3.
Pull out the drain hose to ensure there are no sharp
bends.
4.
On the bottom rear of the dishwasher there is a
black ziptie around the rubber buffer that holds the
circulation pump in place. Cut the ziptie and remove it.
5.
Start to feed water and drain lines and electric cord
(if necessary) into the access hole in the cabinet.
6.
Gently slide the unit into the dishwasher opening.
As you do this, feed the drain line into the drain line
and inlet hose into the access hole in the side of
the cabinet.
Remove the two
screws on each
side of the guard
plate.
Toe kick bracket
After the screws are removed, grip the bottom of the
guard plate and pull it toward you to remove it. You can
now access the inlet valve, electrical connection, and
drain pump and hose, as illustrated below.
As you slide the unit into place, feed the drain line and
inlet hose into the access hole in the side of the cabinet.
WARNING! Be careful of sharp edges.
Page 7
Pagina afdrukken