ASL INTERCOM DANS01 Instrukcja instalacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria ASL INTERCOM DANS01. ASL INTERCOM DANS01 12 stron. Ip65 dynamic ambient noise sensor
Drukuj stronę
12.
Connect the field wiring; see
Figure 5
DANS01 field wiring connection
TO FRONT PANEL PCB
13.
Reconnect any disconnected wiring and front panel tethers.
Refer to step
4
and
Refer to Section
"Connections"
14.
Power the DANS01 on from the central equipment rack.
The LED on the front panel illuminates to indicate that the unit is powered.
15.
Secure the front panel by screwing it tight to provide an IP65 seal, but not excessively tight so that
any of the fixing threads are stressed, as this may cause them to weaken and shear.
16.
The installation is complete.
17.
Commission the DANS01.
DANS01 – Installation Guide
Figure
5.
Refer to Section
"Connections"
(page 12).
Figure 1
(page 5) for disconnected wiring and tethers.
(page
9
for connection details, if required.
Issue: 02 complete, approved
ROUTER AND RACK
The cable screen
!
!
should be terminated
to the brass terminal.
Page 8 of 12
Gland and cable entry point shown
as example only.
FIELD WIRING TO