AMD DIrect GWS-23R Instrukcja instalacji i obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Akcesoria do kominków AMD DIrect GWS-23R. AMD DIrect GWS-23R 6 stron. Glass windshields
Drukuj stronęINSTALLATION FOR RECTANGULAR/SQUARE WINDSHIELDS
NOTE: This section covers both square and
rectangular windshields. Review the assembly for
a rectangular windshield then go directly to STEP 3,
Fig. 8. to assemble a square windshield. Use Fig. 8 for
reference.
STEP 1: Begin by securing two long glass panels inside a
straight bracket. Screw heads should be on the inside of
the assembly. Each glass panel should slide all the way
into the bracket and top edge should be flush with edge of
glass. See Fig. 6.
Top
Fig. 6 Securing two long glass panels into the straight
bracket.
STEP 2: Connect the two long glass panels at the bottom
using another straight bracket in the same manner. Install
two bottom U-brackets approximately 1-inch away from the
straight bracket. See Fig. 7.
Inside View
Bottom
U-Brackets
Fig. 7 Securing the straight bracket and two bottom foot
supports with the Phillips screwdriver.
Note: All bottom brackets are provided with a soft pad to
prevent any scratching of the fire pit table top surface
Glass Windshields
Top
.
STEP 3: Connect end (short) glass panels using the corner
brackets. Ensure the corner connector (with foot) is
located at the bottom and the other corner connector
(without foot) is connected at the top. See Fig. 8.
Inside View
Fig. 8 Securing the corner brackets with a Phillips
screwdriver.
STEP 4: Using one pair of connectors at a time, connect a
single glass panel at either end using corner connectors to
complete the assembly of the rectangle windshield. See
Fig. 8. The short panels are the ends and the long panels
are the sides. Ensure the bottom connectors (with foot) are
located on the bottom.
Top
Bottom
REV. D
Page 3