Aktobis D033FT Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Grzałka Aktobis D033FT. Aktobis D033FT 5 stron.

the room temperature，the thermostat button can be turned from 0 to 270 degree.

THERMOSTAT INSTRUCTIONS

At first turn the thermostat to "Max" and let the heater operate with full power

input. When the room temperature reaches the required value, turn the thermostat

to left until it switches off.

The thermostat will then switch on and off automatic to control the room temperature

according to the preset value and keep the room temperature constant.

When using the heater for the first time, you may notice a slight emission of smoke.

This is quite normal and it stops after a short time. The heating element is made

of steel and was coated with a layer of protection oil by production. The smoke is

caused by the left oil when heated.

After the use turn the thermostat to OFF position and turn the selector switch to

Fan level, let the appliance cool down for two minutes. For appliances with time

delay stopping function, even the power switch is off, the delay circuit may turn

on the appliance if the inner temperature reached the preset function value. The

delay time depends on the ambient temperature. For 20 C ambient it is ca. 3-4 minutes.

If the ambient temperature keeps being more than 27C so the delay device can not

cool down, the delay time may be very long or the delay circuit doesn't open，

hereby the user can only disconnect the appliance from the power supply by pulling

out the plug.

Installation case Illustrate:

Use M5X22 Screw 、Ø5 spring washer、 Ø5x10 flat washer fit on shell，

Tighten the M5X22 screw.

Connect with duct Installation case Illustrate