American Standard 0670 MORNING Instrukcje instalacji
Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Armatura kuchenna i łazienkowa American Standard 0670 MORNING. American Standard 0670 MORNING 2 stron. American standard above counter sink installation instructions
Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To
help insure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also,
review the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.
OBSERVE LOCAL PLUMBING AND BUILDING CODES
Recommended Tools
& Materials
1A
Using the template provided, locate the position of the sink. Provide proper
clearance under the countertop for the fauce t supply lines, drain assembly and
the structural parts of the cabinet.
NOTE: If replacing an existing sink be certain to shut off water supply before
removing old sink.
1B
Wall-mount faucet installations:
Insure sufficient spout overhang into
the sink. See manufacturer's
installation instructions and roughing-
in notes for minimum spout lengths.
Countertop faucet installations:
Using the template as a guide, locate the
faucet hole on the countertop. Allow 1"
minimum clearance between:
• the sink and faucet spout
• the sink and end of faucet handles
• the backsplash and faucet spout and handles
Use the faucet installation instructions for
required clearances.
3
A
™
Installation
Instructions
Hacksaw
Pipe Wrench
Channel Lock Pliers
Adjustable Wrench
BACKSPLASH
CUT-OUT
LINE
Mount the faucet and drain
assembly (not included) on
the sink following the
manufacturer's instructions.
Be certain to apply a bead
of sealing putty on the
underside of the drain (Part
"A") in order to ensure a
watertight seal between the
sink and drain. Remove
excess putty after installing
drain on sink.
ABOVE COUNTER SINK
FOR USE WITH:
Tubing Cutter
Phillips Screwdriver
Regular Screwdriver
Basin Wrench
Plumbers' Putty or Caulking
Putty Knife
Tape Measure
Drill
2
Drill a clearance hole inside the
perimeter line of the template.
1" (25mm)
MIN.
Cut opening around the
OUTSIDE
perimeter of the template.
EDGE OF
SINK
NOTE: For Wallmount or
Countertop faucets, drill faucet
holes according to
manufacturer's instructions.
0660 LOFT
0670 MORNING
0680 PETAL
730687-100
Perimeter
of template
Perimeter
of template
A
© American Standard Inc. 2004