AMERITRON SDC-103 Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler AMERITRON SDC-103. AMERITRON SDC-103 13 stron. Automatic screwdriver antenna controller for icom radios

Drukuj stronę

SDC-103 Automatic Screwdriver Controller (ICOM)

Installation

There are seven wires that need to be connected in order for the controller to

function properly.

The red wire needs to be fused and connected to the vehicle's +12

VDC supply. The size of the fuse depends upon the current requirement

of the antenna motor. Typically a 5 Amp slow-blow fuse will work.

Some installations may require additional wire. Use 16 AWG wire to

add additional length.

The black wire needs to be connected to the vehicle (station) ground.

If the supplied red and black wires are not long enough, Use 16 AWG

wire to add additional length.

WARNING: Do not reverse the polarity of the Red and Black

wires. Damage will occur to the controller.

The remaining four wires are connected to the antenna. The Green and

Yellow wires are connected to the motor. The polarity of the motor

connection determines the direction of the antenna. If the motor moves

in the wrong direction, swap the wires or see the menu setup section for

setting the correct direction.

The Brown and White wires are the sensor wires and should be

connected to the magnetic sensor on the antenna. There is no polarity

associated with these wires. The following table shows the wire color

and connections.

Plug one end of the 6 foot mono cable supplied with the controller into

the jack on the side of the controller. The opposite end should be

plugged into the CI-V jack of ICOM radio. This jack is labeled as

remote on most ICOM radios. Check the owner's manual of the radio

for further detail. A longer cable may be used if necessary for your

installation

Red

Black

Green

Yellow

Brown

White

CI-V Mono Cable

+12VDC

Vehicle Ground

Antenna Motor

Magnetic Sensor

SDC-103 to ICOM Radio

Instruction Manual