Akw M11 DigiPump Instrukcja instalacji i obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Pompa wodna Akw M11 DigiPump. Akw M11 DigiPump 20 stron.
Drukuj stronę
Fitting Supply Flow Sensor To Mixer Shower
The Mixer shower has two supply lines – hot and cold water– fit one flow sensor to each line.
Install the filter which is a Y-Pattern strainer, in the correct position to the shower water supply
line(s) and then fit the flow sensor between the filter and the shower heater.
CHECK: Direction of flow arrow moulded on casing is in the correct orientation.
Connect the sensor cables from the flow sensor to the pump (see electrical installation).
Ensure sensors and strainers are accessible for service and maintenance purposes.
Vertical Hot & Cold Water Feed
Fit Flow Sensors between the
strainer and shower.
Allow enough distance so that
the sensors are easily accessible.
Flow
Direction
Confirm shower water supply pipework is
flushed before connecting to the shower
sensor via the strainer.
Any building debris in the water supply to the
shower heater will adversely affect the sensor
function and may also damage the shower
heater.
Horizontal Hot & Cold Water Feed
FILTER IN WRONG POSITION
Flow
Direction
Failure to install the Strainer may invalidate any warranty for the product.
Fit sensor using an approved liquid based thread sealant suitable for nylon threads.
CORRECT
POSITION
Flow
Sensor
Direction
JG Push-Fit
Strainer
CORRECT POSITION
CHECK FILTER POSITION
Strainer
Sensor Tail
Flow
Direction
SENSOR DIRECTION
DO NOT tile over Flow Sensors
They must be accessible for servicing
Flow Sensor
Check Flow Direction
All cable connections must be in a dry location.
11
Flow
Direction
WRONG POSITION
Sensor Cable
CHECK FLOW
Flow
Sensor
Direction
Shower
Sensor Cable
Shower