Ametek Land SPOT Instrukcja instalacji - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Stojaki i stojaki Ametek Land SPOT. Ametek Land SPOT 16 stron. Water cooled mountings including sealed to process variant
Drukuj stronę
SPOT
3)
Insert the SPOT Thermometer
into the Water Cooled
Mounting and secure it in
place with the Sprung retainer
clip (Fig. 3-3).
4)
Unscrew the cable gland shell
and split bush from the Water
Cooled Mounting. Slide the
PoE Cable through the gland
shell and fit the split bush
between the gland shell and
the connector (Fig. 3-4).
5)
Slide the PoE Cable through
the cable gland and attach it
to the Thermometer connector
(Fig. 3-5).
6)
Slide the split bush into the
cable gland and tighten the
gland shell.
the cable is not stretched. Do
not over-tighten the gland
shell.
7)
Close the hinged Back Cap
and secure it in place with the
fastener (Fig. 3-6).
The Thermometer is now
installed in the Water Cooled
Mounting.
If you are using an Analogue
Cable in addition to (or instead
of) the PoE cable, refer to
Section 3.1.
8
Make sure that
Sprung retainer clip
Fig. 3-3
Fig. 3-4
Fig. 3-5
Fig. 3-6
Water Cooled Mountings
Installation Guide