AIR HANDLE AHR Podręcznik użytkownika - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Urządzenia przemysłowe AIR HANDLE AHR. AIR HANDLE AHR 14 stron. Excluding gripper

_________________________________________________________________________________________________

Using the whole hand gives big movements and

therefore a high lifting speed of the hoist, this grip

can be used when handling not fragile goods.

Run the hoist to the desired height using the handle. Move the gripper tool to the object that will be lifted/operated, if

the gripper is composed by a hook or loop, fit it on the object and start to gently run the hoist upward by the handle –

the hoist is now moving upward and lifting the object.

If the gripper is more complex with grip/release functions, fit the gripper to the object and activate (push) the grip

button – see enclosed manual for gripper tool. Gently pull the handle upward and the hoist goes upward lifting the

object.

Run the hoist to the desired height and move the goods to the desired location, push gentle the handle down to lower

– the hoist moves downward.

To release the object the hoist need to be unloaded i.e. air pressure in the hoist system must be down to a level where

the hoist do not start to go up when the object is released. When a mechanical gripper tool is used you often need to

continue down before the gripper tool, hook or loop, can be released from the object. Is a gripper tool with interlock

used, the hoist need to be below the ReleaseOk parameter to release the object – see enclosed manual for gripper tool.

The hoist can be configured to balance the lift object. When the handle signal is zero i.e. in neutral position, you can

after a programmed interval, 30-100ms, take a hold on the lifting object an pull/push this up/down and hereby get the

hoist to follow you movements – this type of control is a bit slower than using the handle. When the hoist is balanced

you can easily steer the object to its destination – note, to be able to release the hoist need to be unloaded which it can

not be when it is balanced.

Do NOT leave the hoist with a lift object in the gripper tool. When the equipment is shut down, the air in the system

will slowly lead out through e.g. cylinder seal and the hoist will sink to its most lower position (or where it may find a

support to lean against). If load is in the gripper tool and external air supply is shut off then possible vacuum system can

stop functioning and the load can fall out of gripper tool.

_________________________________________________________________________________________________

Air Handle e-p AB

Telephone

If you relieve the carpus and give small, precise

movements with your fingertips the hoist will move

with a low and controlled speed, this grip is good

when handling fragile goods, fitting the lift object

when assembly, fixtures e.t.c.

Fax

E-mail

User manual - Side 10 of 14

AHR excluding gripper

User manual AHR V1.0.docx

Website