Follett EU155N Series Instrukcja instalacji i obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Dozownik wody Follett EU155N Series. Follett EU155N Series 20 stron. Ice and water dispensers
Również dla Follett EU155N Series: Instrukcja instalacji, obsługi i serwisu (20 strony), Instrukcja instalacji, obsługi i serwisu (20 strony)

Cleaning bin before use

1. Wipe storage area with Solution A.

2. Rinse thoroughly with clear, potable water.

3. Wipe with Solution B to sanitize.

Periodic cleaning of dispenser

Recommended daily cleaning of drain pan

DO NOT run plastic parts (drain pan, dispense chute cover, dispense wheel)

through a dishwasher.

1. Remove all debris from drain pan.

2. Pour 1 gallon (4L) hot water into drain pan to keep drain lines clear.

Recommended weekly cleaning

1. Remove drain pan and grill and wash with Solution A. Rinse thoroughly.

2. Pour a solution of one cup (8oz/237ml) household bleach mixed with one gallon (3.8L) hot water into drain

pan to help prevent algae growth in drain lines.

Recommended quarterly cleaning (every 3 months)

On push button units, remove dispense switch from dispense chute cover

before cleaning chute cover.

1. Turn power switch to "OFF" position and remove top from dispenser.

2. Remove ice from storage area.

3. Remove dispense chute cover, chute, auger motor assembly, auger and auger tube (page 10).

4. Remove drain pan, grille, dispense wheel and cover plate (page 11).

5. Clean all components and bin storage area with Solution A, rinse thoroughly with clear water and sanitize

with Solution B.

6. Remove clean-out plug from drain line tee on side opposite dispense tower and let bath drain.

7. Use a bottle brush to clean coil with Solution A, then rinse and sanitize with Solution B.

8. Reinstall clean-out plug in drain line tee.

9. Pour potable water into bath to submerge coil.

Putting unit back in service after quarterly cleaning

1. Reassemble components.

2. For manual load units, fill unit with an approved ice (see caution statement on page 1).

3. For automatic load units with R400A/W (R404A refrigerant) icemakers, turn bin signal switch(es) and

dispenser power switch to "ON" position and allow storage area to fill.

4. Push dispense button or lever to test that dispenser is functioning properly.

Quarterly cleaning of icemaker system

Units equipped with icemakers require cleaning of icemaker system at least every three months, and

more often if local water conditions dictate. Failure to clean icemaker system will result in decreased

performance and potential damage to icemaker. Refer to Icemaker Operation and Service Manual.