Electrolux TG092 Podręcznik użytkownika - Strona 32

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zamrażarka Electrolux TG092. Electrolux TG092 37 stron.

Electrolux TG092 Podręcznik użytkownika
32 electrolux
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
1. Remove the plug from the power socket.
2. Tilt back the appliance carefully so that the
compressor cannot touch the floor.
3. Unscrew both adjustable feet.
4. Unscrew the screws of the door bottom hinge.
5. Take off the appliance door by pulling it slight-
ly downwards.
6. Unscrew the top door hinge pin of the appli-
ance then screw it back on the other side.
7. Fit the appliance door on the upper door
hinge pin.
20) If foreseen
8. Remove the lower hinge. Put over the pin in
the direction of the arrow.
9. Unscrew and install the screw on the oppo-
site side.
10. Install the lower hinge on the opposite side
leaving the position of the door unchanged.
11. Screw in the one screw in the place set free
on the other side as well as the adjustable
feet (2 pieces).
12. Remove and install the handle
posite side.
13. Reposition, level the appliance, wait for at
least four hours and then connect it to the
power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter),
the gasket may not fit perfectly to the cabinet. In
that case, wait for the natural fitting of the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service spe-
cialist will carry out the reversibility of the doors at
your cost.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
The appliance must be earthed. The power sup-
ply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is
not earthed, connect the appliance to a separate
earth in compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
20)
on the op-