AirTech ACR60 Instrukcja instalacji i okablowania - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji i okablowania dla Wentylator AirTech ACR60. AirTech ACR60 12 stron.
Drukuj stronę
DESCRIPTION
The fan is a continuously running extract fan for kitchens, utility rooms, bathrooms and toilets.
The incorporated LED display allows the installer to configure the fan to suit its installation.
The display is also used to display the day logger and power run meter. The fan can be wall,
window or panel/ceiling mounted.
INSTALLATION
SITING THE TRANSFORMER (SELV Model only)
1.
The transformer must not be installed in a shower cubicle or enclosure. It must be sited
away from direct sources of water spray and out of reach (1.5m) of a person using a
fixed bath or shower.
2.
Site away from direct sources of heat. Ambient temperature range 0 ºC to 40ºC. Do not
site in an area containing excessive levels of grease.
3.
Decide where to site the transformer and fan and work out the required cable runs.
PANEL/CEILING/ INTERIOR WALL MOUNTING
1.
Cut a 105mm diameter hole.
2.
Loosen the screw at the bottom of the grille, and then remove the grille by carefully
pulling away from the housing.
3.
Mark the screw centres through the holes in the fan back plate. Drill, plug and screw
into position. Attach ducting as required for the installation.
4.
Wire the fan as described in the Wiring section. Adjust any settings as required (see
Setup section).
5.
After installation, ensure impeller rotates freely.
6.
Replace the grille and tighten the retaining screw.
EXTERIOR WALL MOUNTING
1.
For wall mounting cut a 117mm diameter hole through the wall and insert the wall
sleeve. Slope the sleeve slightly downwards away from the fan. Where necessary cut
to length and cement both ends into position flush with the wall faces.
2.
Fix exterior grille into position with the louvres positioned downwards.
3.
Loosen the screw at the bottom of the grille, and then remove the grille by carefully
pulling away from the housing.
4.
Mark the screw centres through the holes in the fan back plate. Drill, plug and screw
into position.
5.
Wire the fan as described in Wiring section. Adjust any settings as required (see Setup
section).
6.
After installation, ensure impeller rotates freely.
7.
Replace the grille and tighten the retaining screw.
WINDOW MOUNTING
For window mounting refer to the instructions provided with the kit.