Atlas DPA-102PM Instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Atlas DPA-102PM. Atlas DPA-102PM 20 stron. Networkable 2-channel power amplifier with dsp
Drukuj stronę
DPA-102PM - Networkable 2-Channel
Power Amplifier with DSP
DPA-102PM Pole Mount – Chassis Side
1. Make sure the pole does not exceed 2" or 51mm. Common pipe for video projector mounting is 1.5" ID plumbing pipe. The OD for
this pipe is 1.9" or 49mm.
2. Make sure the DPA-102PM is unplugged from the AC source.
3. Remove the top hole plug.
4. Secure the pole support bracket using the four screws as shown in the diagram below. Note: the support bracket can only be
installed on the top or bottom of the amplifier.
5. Slide the "U" clamp around the pole and into the bracket slots. Do not force the amp onto the pole. Pay attention to orientation of
the amp.
6. Secure the "U" clamp by adding the washers and nuts to the U Bolt. Clamp the amp onto the pole by tightening the two nuts until
the amp is secure in place. Do not over tighten.
7. DO NOT mount any additional amplifiers to the same bracket. The support bracket is designed to support only one DPA-102PM.
Rack Mount – Optional Accessory Kit
The DPA-102PM can be rack mounted as shown below using the optional rack mount kit, model PA702-RMK.
AtlasSound.com
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
– 10 –
Specifications are subject to change without notice.
Owner's Manual