Atlas Copco LCD 1500 Instrukcja bezpieczeństwa i obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja bezpieczeństwa i obsługi dla Wiertarka Atlas Copco LCD 1500. Atlas Copco LCD 1500 20 stron. Hydraulic core drill
Drukuj stronę
Safety and operating instructions
WARNING Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
►
Learn how the machine is switched off in the event
of an emergency.
►
Release the start and stop device immediately in
all cases of power supply interruption.
Whenever fitting or removing the insertion tool,
►
switch off the air supply, bleed the machine by
pressing the start and stop device and disconnect
the machine from the power source.
WARNING Whipping hydraulic hose
Hydraulic hoses under pressure can whip
uncontrollably if screws loosen or are loosened. A
whipping hydraulic hose can cause severe injuries.
►
Depressurise the hydraulic system before
loosening the connection of a hydraulic hose.
Tighten the nuts on the connections of the
►
hydraulic hoses to the required torque.
Check that the hydraulic hose and the connections
►
are not damaged.
WARNING Noise hazard
High noise levels can cause permanent and disabling
hearing loss and other problems such as tinnitus
(ringing, buzzing, whistling, or humming in the ears).
To reduce risks and prevent an unnecessary increase
in noise levels:
►
Risk assessment of these hazards and
implementation of appropriate controls is essential.
Operate and maintain the machine as
►
recommended in these instructions.
Select, maintain and replace the working tool as
►
recommended in these instructions.
►
If the machine has a silencer, check that it is in
place and in good working condition.
Always use hearing protection.
►
Use damping material to prevent work pieces from
►
'ringing'.
10
Maintenance, precautions
WARNING Machine modification
Any machine modification may result in bodily injuries
to yourself or others.
►
Never modify the machine. Modified machines are
not covered by warranty or product liability.
►
Always use original parts, cutting blades/working
tools, and accessories.
Change damaged parts immediately.
►
►
Replace worn components in good time.
CAUTION Hot working tool
The tip of the working tool can become hot and sharp
when used. Touching it can lead to burns and cuts.
Never touch a hot or sharp working tool.
►
►
Wait until the working tool has cooled down before
carrying out maintenance work.
WARNING Working tool hazards
Accidental engagement of the start and stop device
during maintenance or installation can cause serious
injuries, when the power source is connected.
Never inspect, clean, install, or remove the working
►
tool while the power source is connected.
Storage, precautions
Keep the machine and tools in a safe place, out
♦
of the reach of children and locked up.
© 2015 Construction Tools EOOD | No. 3392 5189 01c | 2015-01-31
LCD 500, 1500
Original instructions