Atlas Copco TEX 12PS KL Podręcznik - Strona 15

Przeglądaj online lub pobierz pdf Podręcznik dla Narzędzia Atlas Copco TEX 12PS KL. Atlas Copco TEX 12PS KL 20 stron.

Drukuj stronę

Safety and operating instructions

When taking a break

♦

During all breaks you must place the machine in

such a way that there is no risk for it to be

unintentionally started. Make sure to place the

machine on the ground, so that it can not fall.

♦

In the event of a longer break or when leaving the

workplace: Switch off the power supply and then

bleed the machine by activating the start and stop

device.

Maintenance

Regular maintenance is a basic requirement for the

continued safe and efficient use of the machine.

Follow the maintenance instructions carefully.

♦

Before starting maintenance on the machine, clean

it in order to avoid exposure to hazard substances.

See "Dust and fume hazards"

♦

Use only authorised parts. Any damage or

malfunction caused by the use of unauthorised

parts is not covered by warranty or product liability.

♦

When cleaning mechanical parts with solvent,

comply with appropriate health and safety

regulations and ensure there is satisfactory

ventilation.

♦

For major service to the machine, contact your

nearest authorised workshop.

♦

After each service, check that the machine's

vibration level is normal. If not, contact your

nearest authorised workshop.

Every day

Before undertaking any maintenance or changing

the insertion tool on pneumatic machines, always

switch off the air supply and bleed the machine by

depressing the start and stop device. Then

disconnect the air hose from the machine.

♦

Clean and inspect the machine and its functions

each day before the work commences.

♦

Check the tool retainer for wear and function.

♦

Conduct a general inspection for leaks and

damage.

♦

Check that the air inlet nipple is tightened and that

the claw coupling is free from damage.

For the machine to maintain the specified vibration

♦

values, always check the following:

Too large a clearance between the insertion tool's

shank and the chisel bushing will generate

increased vibrations. To avoid being exposed to

excessive vibrations, check the chisel bushing for

wear every day.

♦

If the machine has a vibration-absorbing

handle/handles, check that it moves freely (up and

down) and does not jam.

♦

Change damaged parts immediately.

♦

Replace worn components in good time.

♦

Make sure that all the attached and related

equipment, such as hoses, water separators and

lubricators are properly maintained.

Changing the spring pin

TEX 09PS

After each operating period of approximately 75

●

impact hours or four times a year the spring pins

(A) should be changed.

Install the spring pins with the slots in opposite

●

directions and at a 45 degree angle.

TEX 3, 05P, 09PS, 10PS, 12PS

TEX 12PS

Original instructions